Yamaha Kodiak 450 Owner's Manual page 102

raise it to the correct level. NOTICE: Be sure
the engine oil is at the correct level, other-
wise engine damage may result.
7. Check the filler cap O-ring for damage, and
replace it if necessary.
8. Install the engine oil filler cap and the panel.
To change the engine oil (and replace the oil fil-
ter cartridge)
1. Place the ATV on a level surface.
2. Remove panel E. (See page 8-8.)
3. Start the engine, warm it up for several minu-
tes, and then turn it off.
4. Place an oil pan under the engine to collect
the used oil.
5. Remove the engine oil filler cap, and then re-
8
move the engine oil drain bolt and its gasket
to drain the oil from the crankcase.
[ECB00852]
1. Engine oil drain bolt
2. Gasket
TIP
Skip steps 6–10 if the oil filter cartridge is not be-
ing replaced.
6. Remove panels C and D. (See page 8-8.)
7. Remove the oil filter cartridge with an oil filter
wrench.
8-19
2
1