Yamaha Kodiak 450 Owner's Manual page 112

1. Coolant drain bolt
2. Gasket
8
1
1. Trough
6. Remove the coolant reservoir cap.
7. Disconnect the coolant reservoir hose on the
1 2
1
1. Coolant reservoir hose
8. After draining the coolant, thoroughly flush
9. Install the coolant drain bolt and its new gas-
Tightening torque:
10. Connect the coolant reservoir hose.
8-29
coolant reservoir side, and then drain the
coolant from the coolant reservoir.
the cooling system with clean tap water.
ket, and then tighten the bolt to the specified
torque.
Coolant drain bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)