Installing The Batteries - Garmin 012-01097-00 Owner's Manual

G S >
ettInG tarted

Installing the Batteries

The Receiver operates on two AA batteries (not
included), which are located in the back of the unit.
You can use Alkaline or NiMH batteries. See page 67
for information on setting the battery type.
To install the batteries:
1. Remove the battery cover
2. Insert the batteries,
3. Reinstall the battery cover
Battery
Compartment
Remove the batteries from the Receiver when you do
not expect to use the unit for several months. Stored
data is not lost when batteries are removed.

Tracking System Owner's Manual F2 2
by turning the D-Ring 1/4
turn counter-clockwise and
pulling the cover loose.
observing the proper
polarity. A polarity diagram
is molded into the battery
compartment.
by aligning the back cover
with the unit and turning the
D-Ring 1/4 turn clockwise.
To install the Lanyard:
1. Place the loop of the Lanyard through the slot
at the at the upper left side on the back of the
unit.
2 Route the strap through the loop and pull tight.
Wrist Strap
Installation
Refer to page 9 for information on accessing the
microSD data card in the battery compartment.
Tracking System Owner's Manual - Draft
Belt Clip Button
attaches here.
(Be certain to fully
engage threads and
tighten snug)
1/16/2007 1:51:41 PM