Table of Contents
Advertisement
• Off Course Alarm—sets an alarm to sound
when you are off your chosen course.
• Deep Water Alarm/Shallow Water Alarm—
sets an alarm to sound when you enter an area
of water that is too deep or too shallow.
Time Setup
Use the Time Setup Page to set the time format and
zone and to set the unit to conform to Daylight Saving
Time. The time and date appear at the base of the page.
• Time Format—sets 12 or 24 hour format.
• Time Zone—sets the time zone for your
city so the Receiver shows the correct local
time. Select Other to enter a Universal Time
Coordinate offset in the field below.
Units Setup
Use the Units Setup to customize measurement units.
• Position Format—sets the coordinate system
in which a particular location is shown. The
default format is latitude and longitude in
degrees, minutes, and thousandths of a minute
o
(hddd
mm.mmm).
Tracking System Owner's Manual - Draft
Tracking System Owner's Manual F37 37
• Map Datum— sets the description for
geographic location for surveying, mapping,
and navigation and is not an actual map built
into the unit. The default setting is WGS 84.
The unit automatically chooses the best datum
based on your chosen format.
For more information about selecting Position
Formats and Map Datums, see page 99.
• Distance/Speed—sets the unit of measurement
to show your speed and distance traveled.
• Elevation (Vert. Speed)—sets the unit of
measurement (Feet (ft/min), Meters (m/min),
or Meters (m/sec)) to show your rate of ascent.
• Depth—sets the unit of measurement (Feet,
Fathoms, or Meters) to show the depth.
• Temperature—sets the unit of measurement
(Fahrenheit or Celsius) to show temperature.
• Pressure—sets the unit of measurement
(Inches, Millibars, or Hectopascals) to show
pressure.
M
M
>
aIn
enu
1/16/2007 1:51:46 PM
Advertisement
Table of Contents
