Air Ventilation; Place Your Projector Correctly - Optoma EX536 User Manual

Air ventilation

Openings in the casing are designed for ven-
tilation and overheating prevention. DO NOT
block or cover these openings to keep your
projector in normal operation and from over-
heating.
Note:
Heat exhaust at the air outlet Keep the
following in mind when using or installing
your projector:
–
sprayers near your projector.
– Keep the air outlet one meter away
from other objects.
– DO NOT touch the area close to the air
outlet especially the metal components,
e.g. screws. This area and parts will get
very hot once your projector starts op-
erating.
– DO NOT place any object atop your
projector. They may not only be dam-
overheated.
Cooling fans are designed for cooling
your projector. Fan speed is auto adjusted
subject to internal temperature of your
projector.
Air intake
Air outlet
(For heat exhaust)
Safety operation guideline

Place your projector correctly

Use your projector at specified location in
correct way. Invalid projector location may
shorten life-cycle of lamps or even lead to
Note:
Avoid installing your projector as illustrated
below.
DO NOT tilt your projector more
than 10 degrees.
DO NOT tilt your projector more
than 10 degrees.
DO NOT put the projector on a
vertical projection.
DO NOT put the projector up-
side down to make a projection.
DO NOT put the projector on a
horizontal projection.
Note:
Precautions on ceiling mount
racket installation:
Get qualified technician to install the
ceiling mount racket.
Warranty of your projector does not
cover hazards and damage caused by
using ceiling mount rackets provided
by unauthorized dealers.
Remove the ceiling mount racket when
it is not in use.
Apply torque driver instead of power
driver or impact driver in your projector.
9