System - Optoma EX536 User Manual

Display

System

System selection
The scanning system and auto computer adjustment function may detect scores of signal format.
If a PC is selected as the input signal source, your projector will detect and adapt to its signal for-
mat automatically. Correct image can be displayed without any setup operation.
Your projector will display one of the following:
If your projector failed to identify
Auto
signals not shown in the signals
format table, the "Auto" message
will display in the System Signal
Format menu. The Auto PC Ad-
justing function will make neces-
sary adjustment to your projector
to project valid images. If images
are displayed incorrectly, adjust it
manually.
No PC signals detected. Check
-----
the connection between PC and
your projector.
Select the computer system manually.
1 Press the MENU button on remote controller
and the OSD displays. Press
to the Input icon, press
and the Input menu displays.
2 Press button to select System Signal For-
mat, then press OK button.
3 Press button to select required system sig-
selection.
button to point
button or OK button
40
Computer system menu
The selected system displays in the
PC system menu.
Note:
Your projector may save data generat-
ed by the Auto PC Adjusting function.
Note:
The computer system menu will be
disabled once HDMI 1,HDMI 2(MHL),
Memory Viewer,Network,USB Display
has been selected.