Using Inittool.exe On The Usb Key - IBM Storwize V7000 Quick Installation Manual

Note: The Storwize V7000 service IP addresses are not set by the USB Initialize or
by the initial configuration done by the Easy Setup Wizard. Refer to "Next steps"
on page 67 for how to set them.
Additional information must be ready before you start the initial configuration of
your system using the Easy Setup Wizard. Refer to "Information required before
starting initial configuration of your system" on page 51.

Using InitTool.exe on the USB key

The USB key is required to initialize the enclosures and file modules.
1. Locate the USB key that was shipped with your order in the documentation
2. Insert the USB key into a USB port in a personal computer that is running
48
Storwize V7000 Unified: Quick Installation Guide
Table 9. The following IP address information is required before initializing your system. Fill
in all the information needed in the Value column before proceeding with this
installation. (continued)
Field
Storwize V7000 Unified
management IP address
File module 1 IP address
File module 2 IP address
package.
Note: You might encounter a problem where the code cannot be run if you use
your own USB key. The USB key that you use must:
v Contain a FAT32 formatted file system on its first partition. NTFS and other
file system types are not supported.
v Contain a copy of the Microsoft Windows USB key InitTool.exe executable
that is located in the root directory of the file system.
v Be write enabled.
Microsoft Windows XP Professional or higher.
If the system is configured to autorun for USB keys, the initialization tool starts
automatically. Otherwise, open the USB key from My Computer and
double-click the InitTool.exe.
Note: If you are running a non-Windows operating system, skip to 4 on page
49.
Value Notes
Designated customer
management IP for the
Storwize V7000 Unified
system. This gives access to
the active management node
running on a file module
(such as 123.123.123.9)
The service access IP address
assigned to file module 1
(such as 123.123.123.10)
The service access IP address
assigned to file module 2
(such as 123.123.123.11)