ProForm Trainer 30464.0 User Manual page 9

7. Set the Console Assembly (91) face down on a
soft surface to avoid scratching it. Hold the Right
Handrail (33), which has a large hole in one
side, near the Console Assembly.
Next, insert the console wire and the tie into the
hole in the side of the Right Handrail (33). Using
needlenose pliers, pull the console wire out of
the hole near the bracket on the Right Handrail.
Then, set the Right Handrail (33) on the Console
Assembly (91). Make sure that no wires are
pinched. Finger tighten an M5 x 16mm Screw
(85) with an M5 Star Washer (7) into the Right
Handrail, and then finger tighten two M4.2 x
19mm Screws (10) into the Right Handrail.
Tighten the M5 x 16mm Screw and then the
two M4.2 x 19mm Screws; do not overtighten
the Screws.
Attach the Left Handrail (not shown) to the
Console Assembly (91) in the same way.
Note: There are no wires on the left side.
8. Remove the plastic ties from the Right Handrail
(33) and the Left Handrail (not shown). With the
help of a second person, hold the Console
Assembly (91) near the Right Upright (54).
Remove the wire tie from the Wire Harness (39).
Connect the Wire Harness to the console wire.
See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Insert the connectors and the ex-
cess wire downward into the Right Upright (54).
9. Attach the Console Assembly (91) to the Right
Upright (54) and the Left Upright (53) with four
M8 x 15mm Bolts (8) and four M8 Star Washers
(5). Do not tighten the Bolts yet. Make sure
that no wires are pinched.
7
Console
Wire
Tie
Bracket
Large
33
Hole
91
8
33
Console Wire
39
Wire
54
9
91
8
5
54
9
85
7
10
91
Console
Wire
Tie
39
8
5
53