ProForm PFTL91105.0 User Manual page 10

8. Note the location of the 75 ohm antenna terminal on the
treadmill. For the television to operate properly, an an-
tenna, a CATV cable, or a VCR must be connected to the
75 ohm antenna terminal (see page 11).
9. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place; the allen
wrench is used to adjust the walking belt (see page 27).
If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Make sure that the key is removed from the con-
sole and that the power cord is unplugged.
Remove the indicated Screws (3) from the back of the
Console Base (85).
2. Connect the wire on the receiver (A) to the indicated
wire on the Console (34). Hold the receiver so the
small cylinder is oriented as shown. Next, remove
the tape from the back of the receiver, and press the
receiver onto the Console Base (85) in the location
shown.
3. Make sure that no wires are pinched. Reattach the
Console (34) with the Screws (3). Discard the other
wires included with the receiver.
8
Small Cylinder
34
Wire
3
10
75 Ohm Antenna
Terminal
A
85
3
3
3