Assembly - ProForm PFTL38581 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The treadmill walking deck is coated with
high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the
walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there
is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
During assembly, refer to the drawings
at the right to identify the small parts
used in assembly.
Assembly requires a phillips screw-
driver , an adjustable
wrench , and scissors
(not included), as well as the included
allen wrench .
1. With the help of a second person, carefully raise the
Uprights (14), the right Handrail (2), and the Console Base
(6) until the treadmill is in the position shown. Be careful
not to pull on the Wire Harness (26). Set the Right
Handrail on the right Upright until step 3 is completed.
Refer to the inset drawing. Insert one of the Extension
Legs (41) into the treadmill as shown. (Note: It may be
helpful to tip the Uprights (14) in the direction shown by
the arrow as you insert the Extension Leg.) Make sure
that the Base Pad (36) is on the bottom of the Extension
Leg. Attach the Extension Leg with an Extension Leg
Screw (34). Be sure to push on the head of the
Extension Leg Screw while tightening it.
Attach the other Extension Leg (41) in the same way.
2. Cut the plastic ties that hold the cage nuts in each
Handrail (2).
Position one of the Handrails (2) on the left Upright (14).
The lower end of the Left Handrail should be resting
against the bracket on the Extension Leg (41) as shown.
Thread a Handrail Bolt (15) with a Handrail Washer (16)
into the left Upright and Handrail. Do not tighten the
Handrail Bolt yet.
Make sure that the hole in the bracket on the Extension
Leg (41) is aligned with the hole in the Handrail (2).
Tighten an Extension Leg Screw (34) into the bracket and
Handrail.
Washer (16)Ð2
3/4" Screw (59)Ð4
Handrail Bolt (15)Ð2
1
2
5
1/2" Screw (13)Ð2
Extension Leg Screw (34)Ð4
6
2
14
36
Plastic Tie
15
16
14
34
Bracket
41
26
14
34
41
2