Install Batteries - Sharp xe-a130 Manual

Before Operation

Install Batteries

Batteries must be installed in the cash register to prevent the data and user-programmed
settings from being erased from memory, when the AC cord is accidentally disconnected or in
case of power failure. Please purchase and install three AA batteries before proceeding with
setup and use of this cash register. Once installed, the batteries will last approximately one
year before needing replacement. At this time, the "l" symbol will appear on the display to
indicate that the batteries are low and that you must replace them within two days.
Install batteries according to this procedure with the AC cord con-
nected and set to "REG" mode position.
1. Push the printer cover forward and detach it.
2. Open the battery cover next to the paper roll cradle.
3. Insert three new AA batteries.
4. Confirm the low battery symbol "l l l l l " lights off.
5. Close the battery cover.
6. Replace the printer cover.
C
Incorrectly using batteries can cause them to burst or leak, possibly damaging the
interior of the cash register. Note the following precautions:
• Be sure that the positive (+) and negative (-) poles of each battery are facing in the
proper direction.
• Never mix batteries of different types.
• Never mix old batteries and new ones.
• Never leave dead batteries in the battery compartment.
• Remove the batteries if you do not plan to use the cash register for long periods.
Should a battery leak, clean out the battery compartment immediately, taking care to
avoid letting the battery fluid come into direct contact with your skin.
Install the Paper Roll
Always install the paper roll even when you set the register for not printing receipt.
In the case of receipt printing
1. Push the printer cover forward and detach it.
2. Push the paper roll release lever in the arrow direction and
install the paper roll onto the paper roll holder correctly.
6