Suzuki Wagon R Plus RB310 Service Manual page 18

• When installing the wiring harness, fix it with clamps so
that no slack is left.
• When installing vehicle parts, be careful so that the wir-
ing harness is not interfered with or caught by any other
part.
• To avoid damage to the harness, protect its part which
may contact against a part forming a sharp angle by
winding tape or the like around it.
• Be careful not to touch the electrical terminals of parts
which use microcomputers (e.g. electronic control unit
like as ECM, PCM, P/S controller, etc.). The static elec-
tricity from your body can damage these parts.
• Never connect any tester (voltmeter, ohmmeter, or what-
ever) to electronic control unit when its coupler is dis-
connected. Attempt to do it may cause damage to it.
• Never connect an ohmmeter to electronic control unit
with its coupler connected to it. Attempt to do it may
cause damage to electronic control unit and sensors.
• Be sure to use a specified voltmeter/ohmmeter. Other-
wise, accurate measurements may not be obtained or
personal injury may result. If not specified, use a voltme-
ter with high impedance (M
type voltmeter.
GENERAL INFORMATION 0A-13
Ω
/ V minimum) or a digital