Table of Contents
Advertisement
6A2-28 ENGINE MECHANICAL (M13 ENGINE)
2
1
4) Install new O-rings (2) in the position as shown in figure and
install oil pump strainer (1).
Tighten strainer bolt (3) first and then bracket bolt (4) to
specified torque.
Tightening torque
Oil pump strainer bolt (a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
Oil pump strainer bracket bolt
(b): 11 N·m (1.1 kg-m, 8.0 lb-ft)
5) After fitting oil pan to cylinder block, run in securing bolts and
start tightening at the center:
move wrench outward, tightening one bolt at a time. Tighten
bolts and nuts to specified torque.
Tightening torque
Oil pan bolt and nut (a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
6) Install new gasket and drain plug to oil pan.
Tighten drain plug to specified torque.
Tightening torque
Oil pan drain plug bolt (b): 50 N·m (5.0 kg-m, 36.5 lb-ft)
7) For 2WD vehicle, install Engine rear mounting bracket.
8) For 4WD vehicle, install transfer referring to "Transfer Dis-
mounting and Mounting" in Section 7D.
9) Install clutch housing lower plate (3).
Tighten clutch housing lower plate bolts (c) first and next (d)
with specified torque.
(a)
(b)
Tightening torque
Clutch housing lower plate bolt (c and d)
: 50 N·m (5.0 kg-m, 36.5 lb-ft)
2
(d)
10) Install exhaust manifold stiffener (2) and exhaust No.1 pipe
3
(1).
(c)
Tighten bolts to specified torque.
Tightening torque
Exhaust pipe No.1 bolt (a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
Exhaust manifold stiffener bolt (b):
50 N·m (5.0 kg-m, 36.5 lb-ft)
11) Install oil level gauge.
12) Refill engine with engine oil referring to "Engine Oil and Filter
Change" in Section 0B.
13) Verify that there is no engine oil leakage and exhaust gas
leakage at each connection.
Advertisement
Table of Contents
