Table of Contents
Advertisement
7A2-20 MANUAL TRANSAXLE (M13 ENGINE)
(A)
2
1
3
2
1
(A)
2) Using special tool, remove circlip (1) and then remove hub
plate (2).
Special tool
(A): 09900-06107
3) Drive out spring pin using special tool and hammer.
Special tool
(A): 09922-85811
4) Remove gear shift fork (2), sleeve & hub assembly (3), syn-
chronizer ring spring, synchronizer ring and 5th gear all
together. Use gear puller (1) for removal if spline fitting of
hub is tight.
5) Install input shaft 5th gear (1) and special tool to stop rota-
tion of shafts, and remove countershaft nut (2).
Special tool
(A): 09927-76010
6) Remove special tool, input shaft 5th gear, needle bearing of
separated steel cage type and then remove counter shaft 5th
gear.
7) Remove left case plate screw (1) and bolts (3), and take off
left case plate (2).
8) Remove bearing set shim.
Advertisement
Table of Contents
