Dhcp - TP-Link TL-WR841HP Quick Installation Manual

Chapter 4
• Allow Guest To Access My Local Network
local network and manage it.
• Guest Network Isolation
• Enable Guest Network Bandwidth Control
Bandwidth Control rules will take effect.
Note: The range of bandwidth for guest network is calculated according to the setting of Bandwidth Control on
the Bandwidth Control
4. 6.

DHCP

By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the
router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices
from the IP Address Pool. You can change the settings of DHCP Server if necessary,
and you can reserve LAN IP addresses for specified client devices.
4. 6. 1. DHCP Settings
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to DHCP > DHCP
- If enabled, guests are isolated from each other.
> Control Settings page.
Settings.
Configure the Router as a Standard Wireless Router
- If enabled, guests can access the
- If enabled, the Guest Network
37