Table of Contents
Advertisement
10. Wrap the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
two Finger Guards (37) to the Base (2) with an
M10 x 47mm Button Screw (76) and an M10
Washer (59). Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley.
Note: The Finger Guards (37) attached in this
step will overlap the Finger Guards attached
in step 8.
11. Route the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
two Finger Guards (37) to the indicated hole in
the Base (2) (see the inset drawing) with an M10
x 47mm Button Screw (76) and an M10 Washer
(59). Make sure that the Cable Trap is oriented
to hold the Cable in the groove of the Pulley.
12. Attach a Pulley Bracket (17) to the indicated "U"-
channel (18) with an M10 x 129mm Button Bolt
(72), two M10 Washers (59), and an M10 Nylon
Locknut (56).
Wrap the Long Cable (42) over a 90mm Pulley
(38). Attach the Pulley inside the Pulley Bracket
(17) with an M10 x 41mm Button Bolt (71) and an
M10 Nylon Locknut (56).
13. Wrap the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
two Finger Guards (37) to the Base (2) with an
M10 x 47mm Button Screw (76) and an M10
Washer (59). Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley.
Note: The Finger Guards (37) attached in this
step will overlap the Finger Guards attached
in steps 8 and 11.
10
11
42
38
37
39
Hole
2
12
59
72
71
38
13
42
37
9
37 76
42
37
59
38
39
2
37
76
59
2
18
59
17
56
56
42
76
37
59
38
39
2
Advertisement
Table of Contents
