Table of Contents
Advertisement
17. Attach the Seat (31) to the Seat Frame (8) with
two M6 x 76mm Screws (64) and two M6
Washers (60).
Attach the Bumper (36) to the Seat Frame (8)
with an M4 x 16mm Screw (61).
Slide the Pad Tube (35) into the Seat Frame (8).
18. Grease an M10 x 62mm Button Bolt (75). Attach
the Leg Lever (9) to the Seat Frame (8) with the
Bolt and an M10 Nylon Locknut (56). Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
19. Slide four Foam Pads (32) onto the Pad Tube
(35) and the Leg Lever (9).
20. Set the Seat Frame (8) onto the Upright Base (5).
21. Make sure that all parts have been properly tight-
ened. The use of the remaining parts will be
explained in ADJUSTMENTS, beginning on the
next page.
17
31
35
61
36
18
56
9
19
32
32
9
20
8
11
8
60
64
8
Grease
75
32
35
32
5
Advertisement
Table of Contents
