Power Supply - BENDIX TABS-6 Service Data

Check for high resistance
(corrosion, wire/connector damage
or improper termination) of the
power lines, resulting in a high
voltage drop across the lines.
Measure the voltage under load by
placing a load such as a type 1157
brake light bulb between the Ignition
Power pin and Ground pin of the
ECU connector, while the lamp is in
place.
With ignition power to the trailer,
measure the voltage between the
Ignition Power (pin 1) and Ground
(pin 4) of the ECU connector.
Repeat the voltage measurement
with brake lamp power to the trailer,
between the Brake Lamp Power
(pin 2) and the Ground (pin 4) of the
ECU connector.
The operating range of the module
is 8.0-32.0 VDC. Verify that the
voltage drop measurements are no
less than 1.0 VDC from the vehicle
voltage at both the ignition and
brake power inputs
With a volt/ohm meter, check
the power and ground wiring. Look
for corroded or damaged wires or
connectors.
If repairs are made, rerun the
power-up sequence. Go to
Section A.
If proper loaded and unloaded
voltage is measured at the ECU
connector, and no corrosion or
damage is found on the wiring,
connectors or ECU, replace the
module.
SECTION D: TROUBLESHOOTING THE

POWER SUPPLY

YES
Turn off the power to the
module, disconnect the 7-pin ECU
connector.
the trailer (engine
running), measure the
voltage between the ignition
Power pin and the Ground pin of the
ECU connector.
Repeat the voltage measurement with brake lamp
power to the trailer, and between the Brake Lamp Power
pin and the Ground pin of the ECU connector.
The operating range of the module is
8.0-32.0 VDC. Can you verify that
measurements found are equal
to the vehicle voltage (within
1 VDC) at both the
ignition and brake
With a volt/ohm meter, check the
power and ground wiring. Look for
corroded or damaged wire or connectors.
If repairs are made, rerun the power‑up
sequence. Go to Section A.
Measure the loaded
voltage across a type
1157 brake light bulb.
With
ignition
power to
power
inputs?
NO
Looking into TABS-6
Advanced MC Module 7‑pin
Connector Pigtail Harness
Measure:
Ignition Power (pin 1) to
Ground (pin 4), and
Brake Lamp Power (pin 2)
to Ground (pin 4).
37