▲The power MUST be temporarily disconnected from the radar sensor whenever any tests USING A DYNAMOMETER are conducted on a vehicle equipped with a Bendix ® Power ON Wingman system.
Page 3
FRONT Lift Axle Relay Valve Trailer ABS Module Lift Axle Figure 4 – Typical Trailer Air Brake System with a TLV-9000 Lift Axle Valve ™...
Page 4
Trailer Service Relay Valve (LOAD) Module Control Port Lift Axle Figure 5 – Normal Operation TLV-9000 Valve Lifts the Axle by Exhausting the Suspension Bags & Filling the Lift Bags ™ Lift Axle Suspension Bag Lift Bag Bendix TR-3 ®...
Page 5
ECU. During normal operation the driver does not switch is activated. When the switch is deactivated, the control the lift axle. For drop-axle control Bendix offers a axle will only raise if the trailer payload is under the weight manual override harness available from any authorized requirement (normal load sensing operation).
SERVICE suspension height. The TLV-9000 lift axle valve sold in North America is The valve has two air supply (inlet) ports and four air non-serviceable. See your authorized Bendix service parts delivery (outlet) ports.
Page 7
6. Remove the test plugs and reconnect both lines back to the suspension bag delivery ports (Ports 21). Turn off the power to the TLV-9000 lift axle valve. The lift axle should return to its original position. If the valve does not function as described; or if leakage is...