BENDIX TABS-6 Service Data page 15

Diagnostic Trouble Codes
1st 2nd Diagnostic Code
Digit Digit Description
Lateral Acceleration
8 2 Sensor - Signal Out
Of Range
Internal Lateral
8 3 Acceleration Sensor
- Offset Error
Lateral Acceleration
8 4 Sensor ‑ Sensor
Signal Not Found
External Lateral
8 5 Acceleration Sensor
Signal Not Available
Possible Causes / Repair Information
• Before troubleshooting, verify that the trailer has been parked on
level ground.
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines.
• P erform a Lateral Acceleration Sensor (installation angle) Component
Test using the Bendix ACom
®
higher), and verify that the roll angle of the TABS‑6 Adv MC module
is within ±5° as measured from a flat horizontal plane.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
• Before troubleshooting, verify that the trailer has been parked on
level ground.
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines.
• P erform a Lateral Acceleration Sensor (installation angle) Component
Test using the Bendix ACom
®
higher).
 V erify the roll angle of the TABS-6 Adv MC module is within ±5° as
measured from a flat horizontal plane.
 I f the roll angle is out of tolerance, clear the diagnostic code and
test drive the vehicle.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines:
 T ABS-6 Adv MC module mounted either in 0° or 180° orientation.
• I f the ECU has been configured for an external lateral acceleration
sensor:
 C heck for corroded/damaged wiring or connectors between the
ECU and the external lateral acceleration sensor.
 V erify correct wiring between the ECU and the external lateral
acceleration sensor.
• C heck for corroded/damaged wiring or connectors between the ECU
and the external lateral acceleration sensor.
• V erify correct wiring between the ECU and the external lateral
acceleration sensor.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the Bendix
module.
(DTCs)
(continued)
diagnostic software (version 6.1 or
®
diagnostic software (version 6.1 or
®
TABS‑6 Adv MC
® ™
J1587 J1939
(SID/ (SPN/
FMI) FMI)
099/14 1809/14
099/02 1809/02
099/14 1809/14
099/14 1809/14
15