ProForm PFBE1516.0 User Manual page 8

5. See the inset drawing. Orient the Front Leg Foot
(19) and the Front Leg (3) as shown. Press the
Front Leg Foot onto the Front Leg.
Attach the Front Leg Foot (19) to the Front Leg (3)
with two M4 x 12mm Self-tapping Screws ( 61).
Next, attach the Front Leg to the Seat Frame (2)
with two M10 x 70mm Button Bolts (48), two M10
Washers (45), and an M10 Nylon Locknut (43).
6. Attach the Backrest Bracket (8) to the two
Backrest Frames (9) with four M8 x 45mm Bolts
(52), four M8 Washers (58), and four M8 Nylon
Locknuts (44). Do not tighten the Nylon
Locknuts yet.
Orient the Backrest (18) with the wide end in the
position shown. Attach the Backrest to the
Backrest Frames (9) with four M6 x 48mm Screws
(56) and four M6 Washers (46). Do not tighten
the Screws yet.
7. Pull the Backrest Knob (36) out as far as it will
go. Insert the Backrest Bracket (8) into the slot in
the Seat Frame (2). Then, engage the Backrest
Knob into the Backrest Bracket.
Apply grease to an M10 x 175mm Bolt (51).
Attach the Backrest Frames (9) to the Seat
Frame (2) with the Bolt, two M10 Washers (45),
and an M10 Nylon Locknut (43). Do not over-
tighten the Nylon Locknut; the Seat Bracket
and the Backrest Frames must be able to
pivot easily.
See the inset drawing. Insert an M8 x 16mm
Bolt (60) into the Backrest Bracket (8). Tighten an
M8 Nylon Locknut (44) onto the Bolt.
Tighten the M8 Nylon Locknuts (44) and the
M6 x 48mm Screws (56) used in step 6.
5
45
48
6
Wide
End
52
58
46
56
44
7
9
8
Grease
36
51
45
2 45
43
8
2
43
3
3
19
19
61
18
9
9
46
56
58
52
44
8
44
60
Tall
Side
8