Installation Procedure - Toshiba RAS-B10SKVP-E Service Manual

10-1. Safety Cautions
Air filters
2 Wireless
remote controller
4 Remote controller holder
7 Remote controller
holder mounting screw
When installing the outdoor unit,
leave open in at least two of
directions (A), (B), (C) and (D)
shown in the figure below.
• With the remote controller
cover removed, correctly load
the supplied batteries while
observing their polarity.
• Indoor units connectable with a multi-system outdoor unit (Other indoor units are unavailable.)
RAS-B10SKVP-E, RAS-B13SKVP-E, RAS-B16SKVP-E
• When using a multi-system outdoor unit, refer to the installation manual provided with the model concerned.
More user manuals on

10. INSTALLATION PROCEDURE

Hook
140 mm or more
5 Plasma pure filter
80 mm or more only
when unobstructed to
the front and both sides
100 mm or more
from wall
In principle,
leave open
(C)
200 mm
or more
(B)
Ensure sufficient space
to allow drainage
Before installing the wireless remote controller
2 Wireless remote controller
ManualsBase.com
47 mm or more
1 Installation plate
Hook
Hook
6 Mounting screw
Z Shield pipe
(for extension
drain hose)
Y
50 mm or more
from wall
(D)
(A)
250 mm or more
from wall
Power cord
Extension drain hose
(Option: RB-821SW)
Cover
3 Batteries
– 55 –
For the rear left and left piping
Insert the cushion between
74 mm
the indoor unit and wall, and
or more
tilt the indoor unit for better
installation work.
Do not allow the drain hose
to become slack.
Cut the piping hole
slightly sloped
Make sure the drain hose is
sloped downward.
The auxiliary piping can be
connected at the left, rear left,
rear right, right, bottom right or
bottom left as shown below.
Right
Rear
Bottom
right
left
Bottom right
As shown in the figure, position
power cord and connecting cable
downward, and lead out along
piping connection port.
Insulate the refrigerant pipes
separately, not together.
6 mm thick heat resisting
polyethylene foam
Wall
Left
Rear left