Toshiba RAS-B10SKVP-E Service Manual page 90

No. Part name

Front panel
More user manuals on
Procedures
4) Push "PUSH" part under the front panel
and remove hooks of the front panel from
the installation plate.
Installation plate
Front panel
5) Remove the front panel fixing screws.
(2 pcs.)
6) Push the electric parts box with the right
thumb while pulling the both sides of the
front panel toward you.
<How to assemble the front panel>
1) Push three center positions and two lower center positions of the air outlet, and
then hang the hanging hooks (4 pcs.) at the top side of the front panel to the rear
plate.
2) Insert the electric dust collector and left and right air filters.
Push in the electric dust collector until the protrusions on both sides are completely
inserted into the holders.
If installation is incomplete, the FILTER indicator (orange) may light.
3) Tighten two screws.
• Incomplete hanging or incomplete pressing may cause a dewdrops or generation
of a fluttering sound.
ManualsBase.com
Push
Electric dust Electric dust
collector collector
Electric dust Electric dust
collector collector
Holder Holder
Protrusion Protrusion
– 90 –
Remarks
Pull here Pull here
Push here Push here
Push here Push here
Holder Holder
Protrusion Protrusion