Hitron HCG-P7xDxA32 Instruction Manual page 17

MANUAL
MWB allows WB control to be performed manually following the black body radiation curve.
The configurable color temperature setting range is 1500K to 15000K. The setting can be
performed in 64 steps.
PUSH LOCK
Holds the all pull-in frame The PUSH LOCK function first transfers to PUSH mode and performs
pull-in operation, and then transfers to HOLD mode when pull-in is complete.
14. HLC / BLC
HLC (Highlight Compensation)
HLC luminance signal processing is a function that suppresses or masks the luminance signal. It
reduces the load on watchers' eyes and enhances visibility impaired by strong light sources or
other factors by performing output while suppressing the brightness of high-brightness areas.
CLIP LEVEL HLC mask level
BLC (Backlight Compensation)
The BLC function provides compensation by increasing the brightness of the overall screen so
that subjects being shot with a loss of dark detail due to backlight will have just the right
brightness level.
15.ATR-EX
CONTRAST(LOW/MID/HIGH) Contrast adjustment gain
CLEAR FACE(OFF/ LOW/MID/HIGH) High-frequency component adjustment gain
ATR-EX(Extended)
The ATR function provides gradation compensation with the aim of improving visibility.
It compensates to the optimum gradation on the basis of the luminance information.
This function compresses the dynamic range while storing the contrast component of the subject.
16. DNR
Used to reduce image noise in order to improve the image quality of the camera.
It reduces the noise which is generated under low-light conditions and other high-gain states.
LEVEL Adjusts the NR (3D+2D) strength (0~6)
17. DAY/NIGHT
17-1 AUTO
Camera automatically switches between Day&Night modes according to the D>N & N>D levels.
BURST : Select B/W Burst On/Off
CNTL SIGNAL
Selection of brightness reference for identifying Day/Night Control Signal.
INT ILM levels
EXT1 external sensor inverting.
EXT2 external sensor non-inverting.
 Ext : Camera switches between Day & Night modes according to the D/N EXT input.
(ILM level or GPI Cable)
Delay CNT : Adjust the judgment time for the transition between the Day and Night. (0-255).
DAY>NIGHT Level : Select switching level Day to Night (0-255).
NIGHT>DAY Level : Select switching level Night to Day (0-255)
Day : Camera stays in Day mode (Color)
Night : Camera stays in Night mode (B/W)
16