Ariston M1 10L FF Service Manual page 24

B. Adjust water fill-in temperature with setting buttons.
Changed water
fill-in
temperature
(e.g. 45℃)
C. Adjust fill-in flowrate with setting buttons.
Press down the flowrate setting button. LCD display flashes to show the flowrate setting.
Operate flowrate setting with flowrate setting button.
Set the flowrate range within 10-990L (unit: 10L) as per demands.
After water fill-in amount is set, LCD display flashes to show current setting and fill-in
temperature in 8 seconds.
Flash to show
water fill-in
amount
(e.g. 100L)
D. Open the water-out valve
※ If the mixer valve is used, please turn it to hot-water position.
E. Please close the water-out valve after no buzz is sent from
beeper. Buzz from beeper indicates flowrate setting is reached.
LCD display flashes to show current flowrate setting for 8 seconds.
Please stop fill-in.
Special note: (The water heater is not provided
with auto fill-in stop function.)
Initial (ex-works) flowrate setting is 0L.
Technical Manual for DGI
Priority indication on
Temperature reduction
Reduction
- 24 -
Temperature rise
Increase
Close
water-out
valve