Power Supply Requirements Specifications - Cisco MDS 9132T Installation Manual

Technical Specifications
AC Input Power
Output holdup time

Power Supply Requirements Specifications

The following table provides a sample calculation of power for the Cisco MDS 9132T switch AC input power
supply.
Table 3: Power Dissipation for AC Input Power Supply
Power
Mode
Idle
Idle
Typical
Typical
Typical
Max in
55°C
SFP Transceiver Specifications
The Cisco MDS 9132T switch is compatible with SFP transceivers and cables that have LC connectors. Each
transceiver must match the transceiver on the other end of the cable in terms of wavelength, and the cable
must not exceed the stipulated cable length for reliable communications.
Cisco SFP transceivers support 850 to 1610 nm nominal wavelengths, depending upon the transceiver.
Use only Cisco SFP transceivers on the Cisco MDS 9132T switch. Each Cisco SFP transceiver is encoded
with model information that enables the switch to verify that the SFP transceiver meets the requirements for
the switch. For the list of supported SFP transceivers, see the
For details about SFP transceivers see the
For information about safety, regulatory, and standards compliance, see the
Information for the Cisco MDS 9000
Optics Speed LEM Traffic
Rate
0 NA No 0%
0 NA Yes 0%
16 32G No 50%
24 32G Yes 50%
32 32G Yes 50%
32 32G Yes 100%
Family.
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
Power Supply Requirements Specifications
Specification
20 ms
T e m p e r a t u r e Voltage PSU
Room Normal 1
Room Normal 1
Room Normal 1
Room Normal 1
Room Normal 1
50°C +5% 2
Cisco MDS 9000 Series Compatibility
Cisco MDS 9000 Family Pluggable Transceivers Data
Fan Power Power
Modules at 110 at 220
V/60 Hz V/50 Hz
(Watts) (Watts)
2 76 74
2 118 116
2 100 98
2 150 147
2 159 156
4 231 226
Matrix.
Sheet.
Regulatory Compliance and Safety
55