Cisco MDS 9132T Installation Manual page 38

Installing the Switch in a 2-Post Rack
Note You can align four of the holes in the front rack-mount bracket to four of the screw holes on the front side
of chassis or four of the screw holes on the rear side of the chassis. The holes that you use depend on which
side your chassis need to be put in the cold aisle.
Figure 12: Installing rack-mount brackets on the front side of the chassis
Figure 13: Installing rack-mount brackets on the rear side of the chassis
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
32
Installing the Cisco MDS 9132T Switch