Table of Contents
Advertisement
Connecting the Cisco MDS 9132T Switch
Note
The LEDs for the Fibre Channel ports remain orange until the ports are enabled, and the LED for the
MGMT 10/100/1000 Ethernet ports remains off until the port is connected.
Step 9
If a component is not operating properly, try removing and reinstalling it. If it still does not operate correctly, contact
your customer service representative for a replacement.
If you purchased Cisco support through a Cisco reseller, contact the reseller directly. If you purchased support
Note
directly from Cisco, contact the
Step 10
Verify that the system software has booted and the switch has initialized without error messages. If any problems occur,
see the
Cisco MDS 9000 Series System Messages
representative.
Step 11
Complete the worksheets provided in Site Planning and Maintenance Records for future reference.
Note
A setup utility automatically launches the first time you access the switch and guides you through the basic
configuration. For instructions about how to configure the switch and check module connectivity, see the
Fabric Manager Fundamentals Configuration
Cisco Technical
Support.
Guide. If you cannot resolve an issue, contact your customer service
Guide.
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
Powering Up the Switch
Cisco
51
Hide quick links:
Advertisement
Table of Contents
