Cisco Nexus 9000 Series Configuration Manual page 92

Reenabling Cut-Through Switching
Step 3
This example shows how to enable store-and-forward switching:
switch# configure terminal
switch(config) # switching-mode store-forward
switch(config) #
Reenabling Cut-Through Switching
Cut-through switching is enabled by default. To reenable cut-through switching, use the no form of the
switching-mode store-forward command.
Procedure
Step 1
Step 2
Step 3
This example shows how to reenable cut-through switching:
switch# configure terminal
switch(config) # no switching-mode store-forward
switch(config) #
Cisco Nexus 9000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
78
Command or Action
switch(config)# copy running-config
startup-config
Command or Action
switch# configure terminal
switch(config) # no switching-mode
store-forward
switch(config)# copy running-config
startup-config
Configuring Switching Modes
Purpose
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
Purpose
Enters global configuration mode.
Disables store-and-forward switching mode. Enables
cut-through switching mode.
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.