Configuring A Vlan - Cisco Nexus 9000 Series Configuration Manual

Configuring VLANs
Table 4: Default VLAN Parameters
Parameters
VLANs
VLAN
VLAN ID
VLAN name
VLAN state
STP
VTP
VTP version

Configuring a VLAN

See the Cisco Nexus 9000 Series NX-OS Interfaces Configuration Guide, for information on assigning
Note
Layer 2 interfaces to VLANs (access or trunk ports). All interfaces are in VLAN1 by default.
Note If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
might differ from the Cisco IOS commands that you would use.
Creating and Deleting a VLAN - CLI Version
You can create or delete all VLANs except the default VLAN and those VLANs that are internally allocated
for use by the device.
Once a VLAN is created, it is automatically in the active state.
Cisco Nexus 9000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
Configuring a VLAN
Default
Enabled
VLAN1—A port is placed in
VLAN1 when you configure it as
a switch port.
1
• Default VLAN
(VLAN1)—default
• All other VLANs—VLAN
vlan-id
Active
Enabled; Rapid PVST+ is enabled
Disabled
1
23