Advertisement
Available languages
Available languages
17026897_0908 PowerGrip II NAFTA.book Seite 9 Montag, 22. September 2008 8:52 08
7 Use of PowerMaxx Li
7.1
Battery pack
Charge the battery pack before use.
Removing battery pack: Press battery pack
release (6)
and take out battery pack (7).
Inserting battery pack:
(7) Insert battery pack until it engages.
7.2
Setting the direction of rotation,
engaging the transporting safety
device (switch-on lock)
Do not activate rotation selector switch (4)
unless the motor has completely stopped!
Actuate the rotational direction switch (direction of
rotation setting, transporting safety device) (4).
See page 3 (please unfold).
R = Clockwise setting
L = Counter-clockwise setting
0 = Middle position: transportation safety
device (Switch-on lock) set
7.3
Selecting gear stage
Note: Only activate the slide switch (1st/2nd gear)
(3) when the motor is running.
1st gear (low speed,
particularly high torque)
2nd gear (high speed)
7.4
Setting torque control,
drilling
Turn selector barrel (torque, drilling) (2).
1...5 = Torque setting (with torque control) -
intermediate positions are also possible.
= Drilling stage setting (max. torque,
without torque control)
To avoid motor overloading, do not lock
the spindle.
7.5
Switching power tool on/off,
setting speed
To start the machine, press the trigger switch (5).
The speed can be changed at the trigger switch
by pressing.
7.6
LED lights
(equipment-dependent)
For working on dimly lit areas. The LED lights (8)
light up when the machine is switched on.
8 Use of battery charger
The maximum number of charge cycles can only
reached if an exhaustive discharge of the battery
pack is avoided. If performance diminishes,
recharge the battery pack.
8.1
Charging battery pack
Insert battery pack (7) up to the stop in the
charging compartment (9).
The operating display (11) flashes and the battery
is charged.
When the battery pack is fully charged, the
operating display (11) lights up continuously.
The battery pack can remain in the battery charger
and is therefore always ready for use.
9 Fault when charging
9.1
Warning display (10) lights up
continuously
• Battery pack is not charged. Temperature too
high/too low. When the temperature of the
battery pack is between 0 °C and 50 °C, the
charging process begins automatically.
9.2
Warning display (10) flashes
• Battery pack is defective. Remove the battery
pack immediately from the charger.
• Short circuit between the charging contacts.
Check the contacts for foreign bodies.
10 Tips and Tricks
For special tasks: thanks to the automatic spindle
stop, when the machine is switched off it can also
be used as a screwdriver.
ENGLISH
ENG
9
Advertisement
