Advertisement
Available languages
Available languages
17026897_0908 PowerGrip II NAFTA.book Seite 10 Montag, 22. September 2008 8:52 08
ENGLISH
ENG
When working with long screw bits or bit holders,
we recommend the use of the bit clamping bush
6.31281 (see Accessories chapter).
Drilling
Preferably in 2nd gear (high speed).
Screws
Preferably in 1st gear (low speed) and with torque
control.
Screws in areas that are hard to access
The angle screwdriver attachment (see Accesso-
ries chapter) makes work at difficult-to-access
areas particularly easy.
Thread tapping
Lubricate thread drills.
Select 1st gear (low speed).
Adjust torque control.
11 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Quick-clamping chuck.
Fitting: unscrew protective cap (1).
(To remove a tight protective cap, insert a
metal pin (diameter 4 mm) in the protective
cap bore to assist removal). Screw the quick-
clamping chuck onto the spindle thread.
The quick-clamping chuck can be tightened
(and released again) with an open-jawed
spanner, a/f 17.
B Angle screwdriver attachment.
Fitting: mount on the aluminium neck of the
machine and tighten the clamping screw
with the enclosed Allen key.
C Battery pack
D Bit clamping bush
E Bit box
12 Repairs
Repairs to electrical tools and chargers
must be carried out by qualified
electricians only.
If the mains connection cable of this charger
is damaged, in order to prevent endangering
personnel and property it must be replaced by the
manufacturer, or the Customer Service of the
manufacturer, or a similarly qualified person.
Metabo machines requiring repairs can be sent to
the address specified on the spare-parts list.
10
Please enclose a description of the fault with the
power tool.
13 Environmental Protection
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Battery packs must not be disposed of with regular
waste. Please return faulty or used battery packs
to your Metabo dealer.
Do not throw battery packs into water.
14 Technical Specifications
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
PowerMaxx Li:
U
= Voltage of battery pack
n
= Rated speed
0
Tightening torque for screwing:
M
= soft screwing application (wood)
A
M
= hard screwing application (metal)
B
M
=
adjustable torque (with torque control)
C
M
= maximum tightening torque. When
D
used as a screwdriver.
Max. drill diameter:
D
= in steel
1 max
D
= in softwood
2 max
m
= weight (with battery pack)
G
= Spindle thread
Wear ear protectors!
Battery charger LC 60:
A
=
Voltage of the battery packs
B
=
Charging current
C
=
Charging time
battery pack capacity
1)
Depending on the residual capacity and the
temperature of the battery pack, real charging
times may deviate from the specifications.
Measured values determined in conformity with
EN 60745.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
1)
as a function of the
Advertisement
