Motorola MC9500-K User Manual page 140

8 - 14 MC95XX Series Mobile Computer User Guide
Magnetic Stripe Reader
This section describes how to set up and use the snap-on (Magnetic Stripe Reader (MSR) with the MC9500-K. The
MSR snaps on to the back of the MC9500-K and removes easily when not in use.
When attached to the MC9500-K, the MSR allows the MC9500-K to capture data from magnetic stripe cards. To
download MSR data capture software, visit the Support Central web site.
Attaching and Removing the MSR
To attach, slide the cleat of the MSR into the interface pocket of the MC9500-K and snap into place.
MSR Installation
Figure 8-11
To remove the MSR, press the release button and lift off the MC9500-K.
Using the MSR
Install an MSR enabled application onto the MC9500-K.
To use the MSR:
Attach the MSR to the MC9500-K.
1.
Power on the MC9500-K.
2.
Launch the MSR application.
3.
Swipe the magnetic stripe card through the MSR, with the magnetic stripe on the card facing away from the
4.
MC9500-K. Swipe the card in either direction, up and down or down and up. For best results, gently press
down on the card while swiping to ensure contact with the bottom of the reader.
Swipe Card through MSR
Figure 8-12
The application indicates if the data has been read correctly.
5.