Digital Voice Mode Operation - Icom IC-V82 Instruction Manual

■ Digital voice mode operation

q Set the desired frequency in VFO mode. (pgs. 13, 14)
• Select output power, if desired. (p. 15)
w Push [A•
] then [0•
FUNC OPT
then push [Y Y ] or [Z Z ] several times to select the digital se-
lect mode.
• "DG" appears.
e Rotate [VOL] to turn the digital mode ON.
r Push [Y Y ] once to select the your call sign select mode.
• "myC" appears.
t Push [0•
] for 1 sec. then rotate [VOL] to select the de-
OPT
sired your call sign channel, if you have programmed sev-
eral call signs.
• After selecting the your call sign, push [0•
.
TION SET MODE
NOTE: In the digital mode operation; when "BUSY" indi-
cator appears but no sound comes out the speaker, it
may be caused by the interference of FM mode. In this
case, to prevent interference of FM mode, set the digital
monitor setting (p. 47) to "An(analog)" then listen on the
channel before transmitting by pushing [MONI].
] for enter
OPTION SET MODE
Appears
] to return to
OPT OP
DIGITAL MODE OPERATION
D D When sending a CQ
(continued from step t)
,
y Select "CQ" as the call sign.
- Push [Y Y ] or [Z Z ] several times to select the call sign se-
lect mode.
• "yUC" appears.
- Push [0• ] for 1 sec. then rotate [VOL] to select the de-
OPT
sired channel.
- Push [0• ] for 1 sec. to set "CqCqCq."
OPT
- Push [✱• ] (or [D•
ENT
-
uPush and hold [PTT] to transmit and speak into the micro-
phone at normal voice level.
• Transmit indicator appears and the RF meter shows the output power.
i Release [PTT] to return to receive.
• The other station call sign will be received.
• Received call signs can be stored into the received call record
automatically. See page 44 for details.
]) to exit
CLR OPTION SET MODE
11
.
11
43