Set Up The Lacp System Priority For The Switch - NETGEAR XS512EM User Manual

12- or 24-Port 10-Gigabit/Multi-Gigabit Switch Models XS512EM and XS724EM
The Switch Information page displays.
5. Select System > LAG > LAG Membership.
The LAG Membership page displays.
6. In the LAG ID menu, select the LAG ID.
You can select a LAG from 1 to 8.
7. Enter a name in the LAG Name field.
You can enter a name of up to 15 alphanumeric characters.
8. Select the ports for the LAG by selecting the check boxes that are associated with the port numbers.
A LAG consists of at least two ports.
9. Click the Apply button.
Your settings are saved.
10. To enable the LAG as an LACP LAG, do the following:
a. Select System > LAG > LAG Configuration.
The LAG Configuration page displays.
b. Select the LAG ID of the LAG for which you just set up the port membership.
c. In the Admin Mode menu, select Enable.
d. In the LAG Type menu, select LACP.
The Port Member field for the selected LAG ID shows the ports that you selected in
The LAG Status field for the selected LAG ID shows whether the LAG is established (Up) or not
established (Down).
e. Click the Apply button.
Your settings are saved.

Set Up the LACP System Priority for the Switch

The LACP system priority specifies the link aggregation priority of the switch relative to the devices at the
other ends of the links on which link aggregation is enabled. The default is 32768. A higher value indicates
a lower priority. The value of the priority applies to all LACP LAGs that you set up on the switch.
To change the LACP system priority:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is off-network using
an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
Manage Network Settings
48
Step 8.