Assembly Instructions - Precor M9.20 Owner's Manual

Assembly Instructions

To assist you in the assembly of the treadmill, the items in the hardware kit
shown in Diagram 1, correspond to a particular letter in the alphabet. These
letters appear throughout the assembly instructions. Refer to Diagram 1 while
performing the steps below.
To assemble the M9.20/s treadmill, take the following steps:
1. Locate the power switch at the front of the treadmill. Make sure that the
Diagram 2 Install lift
column
Hood
Crossbeam
Elevation tube
Lift column
Crossbar
Base plate
Ribbon cable
Blocks
2. Obtain appropriate assistance to lay the treadmill on its left-hand side.
3. Pick up and rotate the lift column assembly so that the crossbar is at a 90
4. Slide the crossbar a few inches out of the lift column. Insert the top of the
power switch is in the OFF position and that the treadmill's power cord is
unplugged. Do not assemble the M9.20/s treadmill if it is plugged in.
CAUTION: Do not try to assemble the treadmill by yourself. Because
of the weight of the treadmill and its parts, get additional help from
other people before performing the following steps.
Placing the foam blocks on the hood of the treadmill, as shown in
Diagram 2, helps elevate the treadmill and keep pressure off the hood
and side rail during assembly. Due to the rounded corners on the side rail,
one assistant will need to balance the treadmill on its side, while another
assistant helps you install the lift column assembly.
Note: Right and left are determined while standing to the rear of the
treadmill facing toward the hood.
degree angle to the base of the treadmill and the hole inside the crossbar is
on the same side as the elevation tube. If necessary, remove the lower
cable connector from the hole inside the crossbar.
lift column assembly into the crossbeam. Push the lift column through until
the base plate is flush with the crossbeam. Have your assistant support the
far end of the lift column.
page 11