Checking The Alignment Of The Running Belt - Precor C954 Owner's Manual

C O M M E R C

CHECKING THE ALIGNMENT OF THE RUNNING BELT

The belt is aligned at the factory before shipment. However, during shipment or by
using the treadmill on an uneven surface, the belt might move off center. Proper
belt alignment is important because it allows the belt to remain centered and
assures smooth operation.
Follow these steps to check the alignment:
1. The treadmill has adjustable rear feet. Check to make sure that the running
surface is level (refer to steps 14 and 15).
2. Locate the I/O switch at the front of the treadmill and turn the unit ON.
3. Stand beside the treadmill and press Quick Start. The running belt starts
automatically after the message, " Belt Starting 3, 2, 1,... " appears.
4. Continue standing next to the treadmill and hold down the Speed
the display shows a speed of 3 miles per hour (5 kph).
5. Walk around to the rear of the unit and observe the belt for a few minutes as
it moves.
If the running belt,...
tracks centered on the
running surface
runs or drifts off center
CAUTION: If you notice that the belt needs alignment, make the adjust-
ments at once. Failure to do so might cause the belt to tear or fray
which is not covered by the Precor limited warranty.
6. To stop the running belt, press the red Stop button.
If the belt is functioning correctly, the treadmill is ready to use. Please continue
on to Club Information to learn how to customize the treadmill for your Club.
I A L P R O D U C T S D I
Then,...
the belt is functioning correctly. It is
evenly distributed between the side rails
so no adjustment is necessary.
you need to adjust the belt; see
Aligning the Running Belt, page 42.
V I S I O N
key until
page 19