Table of Contents
Advertisement
MIC IP starlight 7000i
2
Unpacking
–
–
–
–
Caution!
Take extra care lifting or moving MIC cameras because of their weight.
!
The MIC packaging is designed:
–
–
2.1
Parts List - Camera
Quantity
1
1
1
1
1
1
4
1
2.2
Additional Tools
The following table lists additional tools (not supplied by Bosch) that may be required to
install a MIC camera or its accessories:
1 Phillips-head screwdriver to secure the ground lug of the camera
1 Adjustable wrench or socket set to secure the base of the camera to mounting accessories
For canting cameras:
1 Torque wrench with a 5 mm Hex bit (or T30 Torx bit) to remove/install bolts in the yoke arms
Bosch Security Systems
This equipment should be unpacked and handled with care. Check the exterior of the
packaging for visible damage. If an item appears to have been damaged in shipment,
notify the shipper immediately.
Verify that all the parts listed in the Parts List below are included. If any items are
missing, notify your Bosch Security Systems Sales or Customer Service Representative.
Do not use this product if any component appears to be damaged. Please contact Bosch
Security Systems in the event of damaged goods.
The original packing carton is the safest container in which to transport the unit and must
be used if returning the unit for service. Save it for possible future use.
to allow installers to configure the camera inside the shipping box.
to provide a temporary table-top or desk-top stand.
Component
MIC IP starlight 7000i camera
Safety and Unpacking Guide document
Spanner wrench [to remove and to attach the yoke caps in order to cant the
camera if desired, and to remove the access plug from the camera head when
installing the optional illuminator accessory (sold separately)
Quick Installation Guide
base gasket
RJ45 coupler (attached to the RJ-45 connector of the camera)
MAC address labels
Ground screw
Installation Manual
Unpacking | en
11
2017.09 | 0.12 | F.01U.xxx.xxx
Hide quick links:
Advertisement
Table of Contents
