Alcatel-Lucent 7210 Sas-x Service Manual page 365

create — This keyword is mandatory while creating a static MAC.
suppress-standby-signaling
Syntax [no] suppress-standby-signaling
Context config>service>vpls>endpoint
Description
When this command is enabled, the pseudowire standby bit (with value 0x00000020) will not be sent
to T-LDP peer when the given spoke is selected as a standby. This allows faster switchover as the
traffic will be sent over this SDP and discarded at the blocking side of the connection. This is
particularly applicable to multicast traffic.
Default enabled
fdb-table-high-wmark
Syntax [no] fdb-table-high-wmark high-water-mark
Context config>service>vpls
config>template>vpls-template
Description
This command
Parameters high-water-mark — Specify the value to send logs and traps when the threshold is reached.
fdb-table-low-wmark
Syntax [no] fdb-table-low-wmark low-water-mark
Context config>service>vpls
config>template>vpls-template
Description
This command
Parameters
low-water-mark — Specify the value to send logs and traps when the threshold is reached.
7210 SAS-X, R6 OS Services Guide
Values 6-byte mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx). (Note: This value
cannot be all zeros.)
specifies the value to send logs and traps when the threshold is reached.
Values 0— 100
Default
95%
specifies the value to send logs and traps when the threshold is reached.
Values
0— 100
Default 90%
Virtual Private LAN Services
Page 365