Canon WFT-E1 Network Setup Manual page 20

Setting Up the Wireless LAN Access Point
Setting the IP Address
For a wireless LAN access point with a DHCP server function, it is recommended to
disable the DHCP server function and fix the IP addresses allocated to the wireless LAN
access point and the FTP server as follows.
If the DHCP server function is enabled, the IP address allocated to the FTP server will
change automatically so the WFT-E1 may not connect to the FTP server.
Enter the IP addresses for the wireless LAN access point and the FTP server and subnet
mask as follows.
If they are already entered, do not change them, and write down the IP addresses
configured in the wireless LAN access point and the FTP server, the subnet mask, and
the range of IP addresses available. The information will be used when setting up the
WFT-E1.
IP address
Wireless LAN access point :192.168.11.1
FTP server
Subnet mask
255.255.255.0
If other wireless LAN equipment is connected to the wireless LAN access point you set up in
this section, change the settings as required. If you use the equipment without changing the
settings, other wireless LAN equipment may not be able to connect to the wireless LAN access
point.
20
:192.168.11.2