Canon WFT-E1 Network Setup Manual page 109

42: FTP server rejected connection
FTP server
1 Is the FTP server set to allow particular IP addresses only?
Change the FTP server settings to allow connections with the TCP/IP [IP address]
set in the WFT-E1.
For Windows 2000 and Windows XP, go to [Start] button
double-click [Network Connections]
[Properties]
[Options] tab
enter TCP port [21]
43: Cannot connect to FTP server.
Error code received from server.
FTP server
1 Are you trying to connect to the FTP server using more than the set maximum
number of simultaneous connections?
Reduce the number of network devices connecting to the FTP server, or increase
the maximum number of devices that can connect to the FTP server using the
following procedure.
For Windows 2000 and Windows XP, increase [Limited To] on the [FTP Site] tab
(p.18).
44: Cannot disconnect FTP server.
Error code received from server.
This error appears if it fails to disconnect from the FTP server for some reason.
Turn off the FTP server's power, the camera's power, and the WFT-E1's power,
and then turn them on again.
double-click [Internet Protocol (TCP/IP)]
double-click [TCP/IP filtering]
[OK] button.
right-click [Local Area Connection]
[ Permit Only]
Troubleshooting
[Control Panel]
[Advanced] button
[Add] button
109