Canon WFT-E1 Network Setup Manual page 111

3 Did you allow access privilege to the FTP server's target folder?
Set the access privilege for the target folder in the FTP server to be able to save
images transferred from the WFT-E1.
For Windows 2000 and Windows XP, set access privileges in the properties of the
target folder.
For Mac OS X, click the target folder, go to the menu's [File]
[Ownership & Permissions] in the screen that appears, change the [You can]
setting to [Read & Write].
4 Is the server's power on?
Turn the server's power on. The power may be turned off in energy saving mode.
5 Is the FTP server's hard disk full?
Increase available space on the hard disk.
47: Image file transfer completion not confirmed by FTP server
This error appears if it fails to receive a confirmation of image file transfer
completion from the FTP server for some reason.
Turn off the FTP server's power, the camera's power, and WFT-E1's power, and
then turn them on again.
61: Same SSID wireless LAN terminal not found
1 Are there any obstacles blocking the path between the WFT-E1 and the
antenna of the wireless LAN access point (or the wireless LAN terminal)?
Move the WFT-E1 and the antenna of the wireless LAN access point (or the
wireless LAN terminal) so there is a clear path between them.
Use the ERA-E1 Extended Range Antenna for the WFT-E1 (sold separately).
2 After a wireless LAN connection is cut off between the WFT-E1 and the
wireless LAN access point (or the wireless LAN terminal) for some reason,
they are not able to connect again.
Turn off the camera's power and the WFT-E1's power, and then turn them on again.
WFT-E1
3 Does the WFT-E1 have the same SSID setting as in the wireless LAN access
point?
Check the SSID in the wireless LAN access point, and set the same SSID in the
WFT-E1. (p.121 [SSID])
4 Is the WFT-E1's antenna loose?
Make sure that the WFT-E1's antenna connection is secure.
Troubleshooting
[Get Info]. In
111