Pairing With Lex Handheld; Holster Sensor - Motorola APX 6000XE User Manual

NOTICE:
If Re-Pair Timer is set to infinite and you clear keys
on the radio, you must clear keys on all previously
paired devices as well. (Please see your
accessories manual for further details.)

Pairing with LEX Handheld

Ensure that Bluetooth feature of your radio is on and the
Bluetooth tones are enabled.
1 Turn on the handheld and activate the Bluetooth
feature.
2 Place the handheld close to the radio aligning the
Bluetooth Pairing Location on the handheld with the
Bluetooth Pairing Location on the radio.
If the pairing process is successful, you hear an
incremental-pitched tone from the radio. The radio
begins to connect to the handheld. If the connecting
process is successful, you hear an incremental-
pitched tone. The display shows <Device Friendly
Name> connected, and the Bluetooth icon turns
from to .
If unsuccessful, one of the following scenarios occur:
Send Feedback
• You hear a short, low-pitched tone and the
display shows Bluetooth pairing failed (if
pairing fails).
• You hear a decremental-pitched tone and the
display shows <Device Friendly Name>
unpaired (if the connection fails within 6
seconds).
• You hear a short, low-pitched tone and the
display shows <Device Friendly Name>
connect failed (if the radio has the pairing
record of the handheld and the connection fails).
Repeat this step to re-initiate the pairing process.
NOTICE:
To unpair the handheld after a successful
connection, follow the steps in
Clearing the Bluetooth Device Information on
page 149.

Holster Sensor

This feature allows a user to suppress one or all holster
events from being reported OTA.
English
Viewing and
151