CORAYVAC
®
I
NSTALLATION
SECTION 1: HEATER SAFETY
Your Safety is Important to Us!
This symbol is used throughout
the manual to notify you of possi-
ble fire, electrical or burn hazards.
Please pay special attention when
reading and following the warn-
ings in these sections.
Installation, service and annual
inspection of heater must be done by a contractor
qualified in the installation and service of gas-fired
heating equipment.
Read this manual carefully before installation, oper-
ation or service of this equipment.
This heater is designed for heating nonresidential
indoor spaces. Do not install in residential spaces.
These instructions, the layout drawing, local codes
and ordinances, and applicable standards that apply
to gas piping, electrical wiring, venting, etc., must be
thoroughly understood before proceeding with the
installation.
Protective gear is to be worn during installation,
operation and service. Thin sheet metal parts, such
as the reflector portion of the heater and the various
venting components, have sharp edges. To prevent
injury, the use of work gloves is recommended. The
use of gloves will also prevent the transfer of body
oils from the hands to the surface of the reflector.
Before installation, check that the local distribution
Figure 1: Top and Side Panel Label Placement
Description
Logo Label
Wiring Label
Gas Connection Label
2 of 54
O
S
M
PERATION AND
ERVICE
ANUAL
Part Number
91007901
91038100
91018125
conditions, nature of gas and pressure, and adjust-
ment of the appliance are compatible.
The heater must be applied and operated under the
general concepts of resonable use.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that they
do no play with the appliance.
For additional copies of the Installation, Operation
and Service Manual, please contact Roberts-Gor-
don Europe Limited.
1.1 Manpower Requirements
To prevent personal injury and damage to the
heater, two persons will be required for installation.
1.2 Safety Labels and Their Placement
Product safety signs or labels should be replaced by
the product user when they are no longer legible.
Please contact Roberts-Gordon or your ROBERTS
GORDON
®
independent distributor to obtain
replacement signs or labels. See Page 2, Figure 1
through Page 3, Figure 2.