Section 1: Heater Safety; Manpower Requirements; Safety Labels And Their Placement; Figure 1: Side And Back Panel Label Placement - Roberts Gorden Blackheat BH20UT Installation, Operation & Service Manual

®
B I
LACKHEAT NSTALLATION

SECTION 1: HEATER SAFETY

Your Safety is Important to Us!
This symbol is used throughout the manual
to notify you of possible fire, electrical or burn
hazards. Please pay special attention when
reading and following the warnings in these
sections.
Installation, service and annual inspection of heater must
be done by a registered installer/contractor qualified in
the installation and service of gas-fired heating
equipment.
Read this manual carefully before installation, operation
or service of this equipment.
This heater is designed for heating nonresidential indoor
spaces. Do not install in residential spaces. These
instructions, the layout drawing, local codes and
ordinances, and applicable standards that apply to gas
piping, electrical wiring, venting, etc., must be thoroughly
understood before proceeding with the installation.
Protective gear is to be worn during installation, operation
and service. Thin sheet metal parts, such as the reflector
portion of the heater and the various venting

Figure 1: Side and Back Panel Label Placement

Logo Label
Back Panel
Description
Logo Label
Fan/Burner Label
Rating Plate Label
2 of 74
O S M
PERATION AND ERVICE ANUAL
Rating Plate Label
Part Number
91033200
91033300
91031300
components, have sharp edges. To prevent injury, the use
of work gloves is recommended. The use of gloves will
also prevent the transfer of body oils from the hands to
the surface of the reflector.
Before installation, check that the local distribution
conditions, nature of gas and pressure, and adjustment of
the appliance are compatible.
For additional copies of the Installation, Operation
andService Manual, please contact Roberts-Gordon LLC.

1.1 Manpower Requirements

To prevent personal injury and damage to the heater, two
persons will be required for installation.

1.2 Safety Labels and Their Placement

Product safety signs or labels should be replaced by the
product user when they are no longer legible. Contact
Roberts-Gordon for obtaining replacement signs or
labels. See Page 2, Figure 1 through Page 3, Figure 2.
Side Panel
Fan/Burner Label