Sharp MX-7090N User Manual page 704

SYSTEM SETTINGS►SYSTEM SETTINGS
Item
Name
Search Number
[Default Settings] tab
Paper Weight Setting
Unit
Paper Type
Paper Information
Paper Property
[Detail] tab
Fusing Temperature Settings
Fuser Pressure Setting
Double Feed Detection Setting
Primary Transfer Current Value
Setting
Secondary Transfer Current Value
Setting
PTC Current Value Setting
Transfer Condition Adjustment
Setting
Motor Speed Setting
Registration Adjustment
Enter a name for the Paper Settings (maximum of 50 half or full width characters).
Set a search number.
Set the paper weight to be used.
Set the units used for the Paper Weight.
Set the paper type.
Select the paper type based on the surface finish of the paper or select the envelope.
The following types can be selected.
• Uncoated Paper
• Coated Paper (Gloss)
• Coated Paper (Matt)
• Embossed
• Envelope
Set when Color paper, Tab Paper, or Pre-Punched paper is used.
Set the properties of the paper to be used.
For the properties, refer to the settings in "Paper Type Registration".
Set the appropriate fusing unit temperature for the paper to be used.
Adjust the pressure on the paper.
Some types of paper such as thick paper may not bend easily, and this may cause
transfer deviations.
You can use this setting to adjust the pressure on the paper and reduce transfer
deviations.
Specify whether double feeds are detected. This function cannot be used when paper
heavier than 68 lbs. (256 g/m
Set the current of the primary transfer unit that is used to transfer toner to the transfer belt.
By adjusting the current of the primary transfer unit, transfer problems such as insufficient
transfer to the transfer belt can be improved.
Select settings for both black & white and 4 color (black, cyan, magenta, yellow).
Set the current of the secondary transfer unit that is used to transfer toner from the
transfer belt to the paper. By adjusting the current of the secondary transfer unit, transfer
problems such as insufficient transfer to the paper can be improved.
When Uncoated Paper is selected for [Paper Type]
Set for the Side 1 and Side 2 for both black & white and color.
When other than Uncoated Paper is selected for [Paper Type]
Select settings for both black & white and color.
Set the PTC discharge current. The PTC discharge current can be adjusted to obtain
transferability suitable for the paper being used.
When Embossed is selected for the [Paper Type]
Set for both black & white and color.
When other than Embossed is selected for [Paper Type]
Set for black & white and color at the same time.
Set enable/disable of transfer environment correction of Primary Transfer Current Value,
Secondary Transfer Current Value and PTC Current Value.
You can adjust the motor speed and the speed change timing.
This performs registration adjustment.
7-107
Description
2
) is used.