Intel® Sas Raid Module Installation / Removal; Intel® Sas Raid Module Installation; Intel® Sas Raid Module Removal; Intel - Intel R1000SPO series Service Manual

Intel

® Server System R1000SPO Product Family System Integration and Service Guide
3.3 Intel® SAS RAID Module Installation / Removal
3.3.1 Intel® SAS RAID Module Installation
1. Install the standoffs (provided with the RAID module) on the positions shown (see label "A").
2. Align the module mounting holes over the three barrel standoffs
3. Press down firmly until the module connector is fully engaged with the matching connector on the
server board and the module is firmly seated over each barrel standoff (see label "B").
4. Insert a locking pin into each barrel standoff and connect cables (see label "D").
3.3.2 Intel® SAS RAID Module Removal
1. Disconnect cables and remove the locking pins from each standoff.
2. Grasp the module near the front standoff and pull up firmly until the front side of the module is clear of
the standoffs.
3. Repeat step 2 to release the other side of the module.
3.4 Intel ®
3.4.1 Intel® I/O Expansion Module Installation
Figure 40. Intel® SAS RAID Module Installation
I/O Expansion Module – Installation / Removal
Figure 41. Installing Intel ® I/O Expansion Module
35