Wired Connection With Automatic Ip Address; Wired Connection With Static Ip Address - Philips NP2500/37 User Manual

» The NP2500 searches for networks.
6
Select your network from the list of found
networks and confirm.
• Enter the encryption key (if required)
and confirm.
• The NP2500 tries to acquire an
automatic IP address.
7
Press BACK
to enter your IP address
manually.
8
Enter your static IP address and confirm.
The NP2500 shows the confirmation
»
for the connection to the network.
» The NP2500 shows the prompt for
the connection to the Internet.
9
Select [Yes] to connect to the Internet.
» The NP2500 shows the confirmation
for the connection to the Internet.
Note
•
You can enter more than one encryption key. In this
case, the NP2500 prompts you to select the default
encryption key.
Wired connection with automatic IP
address
This is how to navigate and select with the
remote control:
• Press or to select a menu option.
Press OK to confirm a selection.
•
Press BACK
• to go back to the previous
screen.
• Press HOME to go to the Home menu.
The alphanumeric buttons of the remote
control are multi-function buttons:
• To select a number or an alphanumeric
character, press a button once or more
until you see the number or alphabetic
character in the display of the NP2500.
• To cycle through the alphanumeric
characters that are available, press a button
repeatedly.
• To delete the last character entry from the
display, press CLEAR.
• To delete the whole last line entry
from the display, press and hold
CLEAR.
The onscreen display guides you
through the process of connecting the
NP2500 to your home network and
the Internet. This section describes
the typical wired setup with automatic
IP address. You can also follow the
onscreen prompts for advanced
configurations that are not described
in this manual.
1
Connect an Ethernet cable (sold
separately) to the ETHERNET jack of the
NP2500 (see 'Rear view' on page 8) and
the Ethernet jack of the wired router.
2
Ensure that the wired router is turned on
and has broadband Internet access.
3
Turn on the NP2500.
4
Press SETTINGS, to go to the Settings
menu.
5
Select [Wired (Ethernet)] to start the
network setup process.
The NP2500 acquires the automatic
»
IP address.
The NP2500 shows the confirmation
»
for the connection to the network.
The NP2500 shows the prompt for
»
the connection to the Internet.
6
Select [Yes] to connect to the Internet.
The NP2500 shows the confirmation
»
for the connection to the Internet.
Wired connection with static IP
address
This is how to navigate and select with the
remote control:
• Press or to select a menu option.
• Press OK to confirm a selection.
EN
29