6 First-time setup
This is how to navigate and select with the
remote control:
•
Press
or
to select a menu option.
Press OK to confirm a selection.
•
Press BACK
•
screen.
Press HOME to go to the Home menu.
•
When you connect the NP2500 to
the power supply for the first time, the
NP2500 displays the prompt for the
language selection.
1
Select the language and confirm.
The NP2500 displays the prompt for
»
the optional demo play.
You have two options:
•
View the demo. (see 'View the demo' on
page 14)
•
Complete the first-time setup. (see 'First-
time connection to home network' on
page 14)
Tip
•
After the first-time set-up, you can change the language
in the Settings menu.
View the demo
1
Select "[Yes, show me the demo]", to view
the demo.
The demo plays continuously until you
»
exit the demo play.
2
To exit the demo play, press
EN
14
to go back to the previous
.
Note
•
The NP2500 remains in first-time setup status until you
select [No] to decline the demo play.
•
You can start the demo play again with the DEMO
button on the remote control or in the Settings menu
of the NP2500.
First-time connection to
home network
After you select [No] to decline to view the
demo, the NP2500 prompts you to select your
location / time zone. The NP2500 also reminds
you to register the NP2500 at www.philips.
com/welcome and to install the PC software.
This is how to navigate and select with the
remote control:
•
Press
or
to select a menu option.
Press OK to confirm a selection.
•
•
Press BACK
screen.
•
Press HOME to go to the Home menu.
1
Select the location / time zone and
confirm.
The NP2500 shows the prompt for
»
the network connection.
2
Select [Yes], to create a connection to the
network.
The NP2500 shows the prompt for
»
the network setup (if no network has
been set up yet).
Select [No] to exit the setup and go
»
to the Home menu.
3
Continue with one of the following
options:
•
First-time setup: Wireless network
connection with automatic IP address (see
'First-time setup: Wireless connection with
automatic IP address' on page 15)
This setup requires the following:
»
to go back to the previous