First-Time Setup: Wired Connection With Automatic Ip Address; First-Time Setup: Wired Connection With Static Ip Address - Philips NP2500/37 User Manual

First-time setup: Wired connection
with automatic IP address
This is how to navigate and select with the
remote control:
• Press or to select a menu option.
Press OK to confirm a selection.
•
Press BACK
• to go back to the previous
screen.
Press HOME to go to the Home menu.
•
The alphanumeric buttons of the remote
control are multi-function buttons:
• To select a number or an alphanumeric
character, press a button once or more
until you see the number or alphabetic
character in the display of the NP2500.
• To cycle through the alphanumeric
characters that are available, press a button
repeatedly.
• To delete the last character entry from the
display, press CLEAR.
• To delete the whole last line entry
from the display, press and hold
CLEAR.
The onscreen display guides you
through the process of connecting the
NP2500 to your home network and
the Internet. This section describes
the typical wired setup with automatic
IP address. You can also follow the
onscreen prompts for advanced
configurations that are not described
in this manual.
1
Connect an Ethernet cable (sold
separately) to the ETHERNET jack of the
NP2500 (see 'Rear view' on page 8) and
the Ethernet jack of the wired router.
2
Ensure that the wired router is turned on
and has broadband Internet access.
3
Follow the steps in chapter First-time
connection to home network (see 'First-
time connection to home network' on
page 14) until the NP2500 shows the
prompt for the network setup.
4
Select [Wired (Ethernet)] to start the
network setup process.
The NP2500 acquires the automatic
»
IP address.
The NP2500 shows the confirmation
»
for the connection to the network.
The NP2500 shows the prompt for
»
the connection to the Internet.
5
Select [Yes] to connect to the Internet.
The NP2500 shows the confirmation
»
for the connection to the Internet.
First-time setup: Wired connection
with static IP address
This is how to navigate and select with the
remote control:
• Press or to select a menu option.
• Press OK to confirm a selection.
• Press BACK to go back to the previous
screen.
Press HOME to go to the Home menu.
•
The alphanumeric buttons of the remote
control are multi-function buttons:
• To select a number or an alphanumeric
character, press a button once or more
until you see the number or alphabetic
character in the display of the NP2500.
• To cycle through the alphanumeric
characters that are available, press a button
repeatedly.
• To delete the last character entry from the
display, press CLEAR.
• To delete the whole last line entry
from the display, press and hold
CLEAR.
The onscreen display guides you
through the process of connecting the
NP2500 to your home network and
the Internet. This section describes
the typical wired setup with static
IP address. You can also follow the
onscreen prompts for advanced
EN
17